- Fastening-Systems
- Metal-Tack Applications
- Metal-Tack Specifications
- Punch-Pins
- Tack-Mounts
- Twist-Tacks
- Drive-Tacks
- Drive-Tacks Specifications
- Amtak Air-Tool
Punch-Pins
Now you can fasten light loads to sheet metal in less time than it takes to drill a hole. This simple, quick fastener is perfect for attaching nameplates, wiring clips and small components to metal doors, electrical cabinets, steel tubing, etc.
Position the Punch-Pin on the tip of the tool, push the tool against the base metal and pull the trigger. The Punch-Pin is driven in a single impact. The fastening is fast and permanent.
Standard Punch-Pins are manufactured from carbon steel and are bright zinc plated. They will pass a minimum 120-hour salt spray test in accordance with ASTM B117. Punch-Pins may be used for a wide variety of applications including electrical contacts and balance weights. Punch-Pins will fasten to sheet metal from 1 to 4 mm. They will also fasten to many soft metals thicker than 4 mm. Metals harder than HRB65 may require a Metal-Tack fastener (available from Amtak).
Please call us if our standard Punch-Pin does not fit your application. Our engineers will be happy to work with you in exploring the possiblilty of a special fastener.
;){kind=link}
Standard Punch-Pins are manufactured from carbon steel and are bright zinc plated. They will pass a minimum 120-hour salt spray test in accordance with ASTM B117. Punch-Pins may be used for a wide variety of applications including electrical contacts and balance weights. Punch-Pins will fasten to sheet metal from 1 to 4 mm. They will also fasten to many soft metals thicker than 4 mm. Metals harder than HRB65 may require a Metal-Tack fastener (available from Amtak).
Please call us if our standard Punch-Pin does not fit your application. Our engineers will be happy to work with you in exploring the possiblilty of a special fastener.
;){kind=link}
;){kind=link}
;){kind=link}
;){kind=link}
Punch-Pin Selection Chart
| Punch-Pin Number |
A Grip Range |
B Shank diameter |
C Ø Head |
D Point Lenght |
E Punch-Pin |
|---|---|---|---|---|---|
| 6140 | 1,02 | 1,52 | 4,75 | 3,18 | 1,02 |
| 6141 | 1,52 | 1,52 | 4,75 | 3,18 | 1,02 |
| 6142 | 2,03 | 1,52 | 4,75 | 3,18 | 1,02 |
| 6143 | 2,54 | 1,52 | 4,75 | 3,18 | 1,02 |